Saturday Group at the Hurst EOC

Every Saturday morning from 9am until around Noon, the Hurst Amateur Radio Club meets for tech-talk and all-around live ragchew at the Hurst EOC, which is located at Hurst Fire Station#2 on Pipeline road.  This is a fun time to get together and talk shop on anything related to Amateur Radio. Usually there isn’t a scheduled format,  we’ll just pick a topic at random and share ideas, information, and answers to questions.

Today’s topic was the Broadband HamNet. I posted about this topic the other day for the first time. I also purchased a WRT54GS router on ebay this week, which arrived in the mail yesterday,  so I was able to bring it with me to flash the firmware and get it ready for the Broadband HamNet.

I’m now officially online at my QTH in Grapevine,  but I wasn’t able to find any other nodes in my area. Of course I only have the stock antennas on the back of the router, inside my home. So its time to find some external antennas and a setup the router outside.

This, of course,  poses some challenges since these routers aren’t really made to be weatherproof.  The coax line enclosurebetween the router and the antenna can’t be more than a few inches (there is probably a formula, but I don’t know what it is).  So you basically have to mount the router right next to the antenna.  There are enclosures that will house the router and a power source, and are weather-proof, and mountable onto a mast or tower.  Listed below are some links I have found for doing all of this.  I’ll probably change or update this list before the project comes to fruition, but for now, here is the build-list I am planning:

  • A WRT54GS router.  There is the version with the most memory, according to this hardware list.
  • An Enclosure.  I found a Multilink RNI-3620 Outdoor Residential Enclosure (Cable Box) on ebay.  Under $24 with free shipping, and it comes with mounting hardware.
  • A couple of Antennas.  The WRT54 routers have dual antennas on the back, which are movable, and connect via a plug called RP-TNC.  Finding the correct connector shouldn’t be too much of  problem, but pay attention to this.  The cool thing about having dual antennas is that I can connect both a directional yagi or dish type antenna and point directly to another node, and also an omni-directional antenna which should listen and talk to anything within a certain distance.  Titan Wireless is a good place to find 2.4GHz antennas for base mounting.
  • A power source.  You can use PoE or you can run an outdoor, weatherproof extension cord up to the router and connect the power directly.  This will depend on where I decide to mount the enclosure.  At this point in time I am thinking about mounting it to the top of my chimney on my 2-story house.  This will be about 30 feet in the air. I could run an extension cord from the chimney, down the side of the house, and into the garage.

I’ll post more about this later.  This is going to be a fun project that I will document each step of the way and post to this blog.  What I really would like to see are nodes around my QTH, so if you happen to be near me, comment on this post.

Leave A Comment...

*